Seat Leon 2013 Workshop Manual page 206

León 2013 ➤ , León ST 2013 ➤
Running gear, axles, steering - Edition 06.2018
♦ Torque wrench - V.A.G 1332-
Removing
– Loosen wheel bolts.
– Raise vehicle.
– Remove wheel.
– Remove spring ⇒ page 215
– Unscrew nut -3- and take off washer -4-.
– Unscrew bolt -5-.
– Use felt-tip pen or similar to mark position of eccentric bolt
-3- in relation to subframe.
– Unscrew nut -2- and pull out eccentric bolt -3-.
– Take out upper suspension link -1-.
Installing
Installation is carried out in reverse order, noting the following:
• The threaded connections of the suspension link may only be
loosened and tightened in the unladen weight position
⇒ page 8 .
Specified torques
♦ ⇒ "5.1 Assembly overview - transverse links", page 195
– Check wheel alignment
5.3.2 Removing and installing upper trans‐
verse link, four-wheel drive
Special tools and workshop equipment required
200
Rep. gr.42 - Rear suspension
.
⇒ page 302 .