Removing And Installing Shield For Rear Axle - Seat Leon 2013 Workshop Manual

León 2013 ➤ , León ST 2013 ➤
Running gear, axles, steering - Edition 06.2018
1.4 Removing and installing shield for rear
axle
Removing
– Remove nuts -1-.
– Pull off shield -2- downwards from subframe and, at the same
time, detach at top -arrow-.
Installing
– Hook in shield -1- in direction of -arrow- and swivel in so that
it engages into top part of subframe.
– Tighten nuts -2-.
Note
After installing shield, check again whether shield lug -2- has en‐
gaged properly in subframe -arrow-.
Specified torques
♦ ⇒ "3.2 Assembly overview - add-on parts for subframe", page
169
158
Rep. gr.42 - Rear suspension