Seat Leon 2013 Workshop Manual page 78

León 2013 ➤ , León ST 2013 ➤
Running gear, axles, steering - Edition 06.2018
♦ Engine support - T10533-
Removing
– Loosen wheel bolts.
– Raise vehicle.
– Remove wheel.
– Remove noise insulation ⇒ General body repairs, exterior;
Rep. gr. 66 ; Noise insulation; Assembly overview - noise in‐
sulation .
– Release rear area of wheel housing liner and fold it forwards.
Vehicles with vehicle level senders
– Remove nut -1-.
– Pull bracket -2- for front left vehicle level sender - G78- and/or
for front right vehicle level sender - G289- out of suspension
link -3-, as applicable
Continuation for all vehicles
– Unscrew nuts -arrows-.
– Pull suspension link out of swivel joint and turn wheel bearing
housing to outside to relieve suspension link.
– Remove pendulum support ⇒ Rep. gr. 10 ; Assembly mount‐
ings; Removing and installing pendulum support .
– Loosen double clamp of exhaust system ⇒ Rep. gr. 26 ; Ex‐
haust pipes/silencers; Assembly overview - silencer .
Vehicles with all-wheel drive
– Disconnect propshaft from gearbox and secure ⇒ Rep. gr.
39 ; Propshaft; Assembly overview - propshaft .
Continuation for all vehicles
72
Rep. gr.40 - Front suspension