Subaru Legacy 2004 Service Manual page 2730

• Tighten the clutch cover installing bolts gradual-
ly. Each bolt should be tightened to the specified
torque in a crisscross order.
Tightening torque:
"
16 N m (1.6 kgf-m, 11.8 ft-lb)
(3)
(5)
(2)
3) Remove the ST.
ST 499747100 CLUTCH DISC GUIDE
4) Install the transmission assembly. <Ref. to 5MT-
33, INSTALLATION, Manual Transmission Assem-
bly.>
2. KS AND K4 MODEL
1) Insert the ST into clutch disc and install them on
the flywheel by inserting the ST end into pilot bear-
ing.
NOTE:
When installing the clutch disc, be careful to its di-
rection.
ST 499747100 CLUTCH DISC GUIDE
(A) Flywheel side
2) Install the clutch cover on flywheel and tighten
the bolts to specified torque.
NOTE:
• When installing the clutch cover on flywheel, po-
sition the clutch cover so that there is a gap of 120#
or more between "0" marks on the flywheel and
clutch cover. ("0" marks indicate the directions of
residual unbalance.)
• Note the front and rear of the clutch disc when in-
stalling.
Clutch Disc and Cover
(1)
(6)
(4)
CL-00115
(A)
ST
CL-00208
CL-13
• Temporarily tighten the bolts by hand. Each bolt
should be tightened to the specified torque in a
crisscross order.
Tightening torque:
"
16 N m (1.6 kgf-m, 11.8 ft-lb)
( 3 )
( 5 )
( 2 )
(A) "0" marks
3) Remove the ST.
ST 499747100 CLUTCH DISC GUIDE
4) Install the transmission assembly. <Ref. to 5MT-
33, INSTALLATION, Manual Transmission Assem-
bly.>
C: INSPECTION
1. CLUTCH DISC
1) Facing wear:
Measure the depth from the surface of facing to riv-
et head. Replace if the facings are worn locally or
worn down to less than the specified value.
Depth of rivet head:
Limit of sinking
0.3 mm (0.012 in)
NOTE:
Do not wash the clutch disc with any cleaning fluid.
CLUTCH SYSTEM
( A )
( 1 )
( 6 )
( 4 ) S T
CL-00013