Subaru Legacy 2004 Service Manual page 2734

NOTE:
Tighten the flywheel installing bolts gradually. Each
bolt should be tightened to the specified torque in a
crisscross order.
Tightening torque:
"
72 N m (7.3 kgf-m, 52.8 ft-lb)
( 5 )
( 3 )
( 8 )
( 2 )
3) Install the clutch disc and cover. <Ref. to CL-13,
KS AND K4 MODEL, INSTALLATION, Clutch
Disc and Cover.>
4) Install the transmission assembly. <Ref. to 5MT-
33, INSTALLATION, Manual Transmission Assem-
bly.>
C: INSPECTION
CAUTION:
Since this bearing is grease-sealed and non-lu-
brication type, do not wash it with gasoline or
any solvent.
1) Damage on sliding surface of facing and ring
gear:
If defective, replace the flywheel.
• EC, EK and KA model
( A )
(A) Flywheel
(B) Ring gear
Flywheel
( 1 )
( 7 )
( 4 )
( 6 )
CL-00021
( B )
CL-00124
• KS and K4 model
( A )
(A) Flywheel
(B) Ring gear
2) Smoothness of rotation
Rotate the ball bearing while applying pressure in
thrust direction.
3) If noise or excessive play is noted, replace the
flywheel.
CL-17
CLUTCH SYSTEM
( B )
CL-00022