Subaru Legacy 2004 Service Manual page 2739

CLUTCH SYSTEM
2) Remove the oil seal.
(A)
(B)
(A) Oil seal
(B) Master cylinder
3) Pull the cylinder boot backward.
(B)
(A) Cylinder boot
(B) Master cylinder
4) Remove the snap ring.
CAUTION:
Be careful to prevent the rod, washer, piston
and return spring from flying out when remov-
ing the snap ring.
D: ASSEMBLY
1) Apply a coat of grease to the contacting surfaces
of the push rod and piston before installation.
Grease:
SILICONE GREASE G40M (Part No.
004404003)
2) Assemble in the reverse order of disassembly.
Master Cylinder
CL-00179
(A)
CL-00048
CL-00156
Tightening torque:
"
10 N m (1.0 kgf-m, 7 ft-lb)
E: INSPECTION
If any damage, deformation, wear, swelling, rust or
other faults are found on the cylinder, piston, push
rod, fluid reservoir, return spring, gasket, clutch
damper cylinder boot or hose, replace the faulty
part.
(A)
(A) Master cylinder body
(B) Return spring
(C) Piston
(D) Stop ring
(E) Push rod ASSY
(F) Cylinder boot
CL-22
(C)
(B)
(F)
(D)
(E)
CL-00157