Subaru Legacy 2004 Service Manual page 2729

CLUTCH SYSTEM
2. Clutch Disc and Cover
A: REMOVAL
1. EC, EK AND KA MODEL
1) Remove the transmission assembly from vehi-
cle. <Ref. to 5MT-31, REMOVAL, Manual Trans-
mission Assembly.>
2) Insert the ST on flywheel.
ST 499747100 CLUTCH DISC GUIDE
( A )
(A) Dual mass flywheel
3) Remove the clutch cover and clutch disc.
NOTE:
• Take care not to allow oil on the clutch disc sur-
face.
• Do not disassemble the clutch cover or clutch
disc.
• Be sure to mark alignment marks on the flywheel
and clutch cover before removing the clutch cover.
2. KS AND K4 MODEL
1) Remove the transmission assembly from vehicle
body. <Ref. to 5MT-33, INSTALLATION, Manual
Transmission Assembly.>
2) Install the ST on flywheel.
Clutch Disc and Cover
ST 499747100
3) Remove the clutch cover and clutch disc.
NOTE:
• Take care not to allow oil on the clutch disc fac-
ing.
ST
• Do not disassemble the clutch cover or clutch
disc.
CL-00112
B: INSTALLATION
1. EC, EK AND KA MODEL
1) Insert the ST into clutch disc and install on the
flywheel by inserting the ST end into pilot bearing.
NOTE:
When installing the clutch disc, be careful of its di-
rection.
ST 499747100
CL-00113
2) Place the clutch cover on flywheel and tighten
the bolts to specified torque.
NOTE:
• When reinstalling, align the alignment marks.
• When installing a new clutch cover and flywheel,
position the clutch cover in order to make the gap
between "0" marks of flywheel and clutch cover
120# or more.
• Note the front and rear of the clutch disc when in-
stalling.
CL-12
CRANKSHAFT STOPPER
( A )
(A) Clutch cover
CLUTCH DISC GUIDE
(A)
(A) Flywheel side
S T
CL-00011
(A)
ST
CL-00282