Subaru Legacy 2004 Service Manual page 2740

7. Clutch Pipe and Hose
A: REMOVAL
1) Remove the air intake chamber. <Ref. to
IN(H4SO 2.0)-8, REMOVAL, Air Intake Chamber.>
2) Drain the clutch fluid. <Ref. to CL-24, Clutch Flu-
id.>
3) Disconnect the clutch pipe from the clutch hose
and master cylinder.
4) Pull out the clamp, then remove the clutch hose
from bracket.
(B)
(A) Clamp
(B) Clutch hose
5) Disconnect the hose from operating cylinder.
6) Remove the bracket.
Clutch Pipe and Hose
(A)
CL-00057
CL-23
B: INSTALLATION
Install in the reverse order of removal.
NOTE:
Bleed the air of clutch fluid. <Ref. to CL-25, Clutch
Fluid Air Bleeding.>
Tightening torque:
"
T1: 15 N m (1.5 kgf-m, 10.8 ft-lb)
"
T2: 18 N m (1.8 kgf-m, 13.0 ft-lb)
"
T3: 25 N m (2.5 kgf-m, 18.4 ft-lb)
T1
T3
(B)
(C)
(C)
T2
(A) Clutch pipe (LHD model)
(B) Clip
(C) Clutch hose
(D) Clutch pipe (RHD model)
C: INSPECTION
Check pipes and hoses for cracks, breakage or
damage. Check joints for fluid leakage. If any
crack, breakage, damage or leakage is found, re-
pair or replace the defective pipe or hose.
CLUTCH SYSTEM
T1
(A)
T1
(D)
T1
T3
(C)
(B)
CL-00283