Subaru Legacy 2004 Service Manual page 2738

6. Master Cylinder
A: REMOVAL
1) Thoroughly drain the brake fluid from reservoir
tank.
2) Remove the snap pin and clevis pin, and then
separate the push rod of master cylinder from
clutch pedal.
(D)
(C)
(A) Clevis pin
(B) Snap pin
(C) Push rod
(D) Lock nut
3) Remove the air intake chamber. <Ref. to
IN(H4SO 2.0)-8, REMOVAL, Air Intake Chamber.>
4) Disconnect the clutch pipes from master cylin-
der.
5) Remove the master cylinder and reservoir tank
as a unit.
CAUTION:
Be careful not to spill the brake fluid. Brake flu-
id spilt on the vehicle body will harm the paint
surface; wipe it off quickly if spilt.
(B)
(A) Master cylinder ASSY
(B) Clutch pipe
B: INSTALLATION
1) Install the master cylinder to the vehicle, and
connect the clutch pipe to master cylinder.
NOTE:
Check that the pipe is routed properly.
Master Cylinder
(A)
(B)
CL-00042
(A)
CL-00152
Tightening torque:
"
T1: 15 N m (1.5 kgf-m, 10.8 ft-lb)
"
T2: 18 N m (1.8 kgf-m, 13.0 ft-lb)
T2
2) Connect the push rod of master cylinder to
clutch pedal, and install the clevis pin and snap pin.
NOTE:
Apply grease to the clevis pin.
(C)
(A) Clevis pin
(B) Snap pin
(C) Push rod
3) After bleeding air from the clutch system, ensure
that clutch operates properly. <Ref. to CL-25,
Clutch Fluid Air Bleeding.>
4) Install the air intake chamber. <Ref. to IN(H4SO
2.0)-8, INSTALLATION, Air Intake Chamber.>
C: DISASSEMBLY
1) Remove the straight pin and reservoir tank.
(A)
(A) Reservoir tank
(B) Straight pin
CL-21
CLUTCH SYSTEM
T1
CL-00153
(A)
(B)
CL-00045
(B)
CL-00178