Subaru Legacy 2004 Service Manual page 2744

B: INSTALLATION
1) Install in the reverse order of removal.
Tightening torque:
"
T: 18 N m (1.8 kgf-m, 13.0 ft-lb)
• Clutch pedal catcher
(A)
(B)
T
(A) Bracket (Clutch pedal catcher)
(B) Clutch pedal catcher
(C) Clutch pedal
(D) Steering support beam
CAUTION:
Always use a new clevis pin.
2) Adjust the clutch pedal after installation. <Ref. to
CL-29, ADJUSTMENT, Clutch Pedal.>
C: DISASSEMBLY
1. LHD MODEL
1) Remove the clutch switches.
2) Remove the clips, assist spring, rod and bush-
ing.
(D)
(A)
(E)
(C)
(D)
(B)
(E)
(C)
(A) Clip
(B) Assist spring
(C) Assist rod
(D) Bushing
(E) Clevis pin
Clutch Pedal
(D)
(C)
CL-00275
(D)
CL-00094
3) Remove the spring pin and lever.
(A) Pin
(B) Lever
4) Remove the clutch pedal and bushings.
(B)
(A)
(A) Clutch pedal
(B) Bushing
5) Remove the stopper, clip and rod S, and then re-
move the spring and bushing S.
(E)
(D)
(A) Clip
(B) Bushing S
(C) Spring S
(D) Rod S
(E) Stopper
6) Remove the stoppers from clutch pedal.
7) Remove the clutch pedal pad.
CL-27
CLUTCH SYSTEM
(A)
CL-00095
CL-00096
(B)
(A)
(C)
CL-00097
(B)
(B)