Subaru Legacy 2004 Service Manual page 2746

4) Install the clutch pedal assembly, stopper, ad-
justing rod, bushing and spring to clutch pedal
bracket.
Tightening torque:
"
T: 30 N m (3.1 kgf-m, 22.4 ft-lb)
(A)
T
(B)
(A) Clutch pedal bracket
(B) Clutch pedal
5) Install the assist rod, bushing and assist spring
to clutch pedal and pedal bracket.
E: INSPECTION
1. CLUTCH PEDAL
Move the clutch pedal pads in the lateral direction
with a force of approximately 10 N (1 kgf, 2 lb) to
ensure the pedal deflection is in specified range.
If excessive deflection is noted, replace the bush-
ings with new ones.
Deflection of clutch pedal:
Service limit
5.0 mm (0.197 in) or less
• LHD model
(A)
(A) Clutch pedal
(B) Brake pedal
Clutch Pedal
CL-00276
(B)
CL-00098
CL-29
• RHD model
(A)
(A) Clutch pedal
(B) Brake pedal
F: ADJUSTMENT
1) Measure the full stroke amount of clutch pedal.
NOTE:
• Measure the length between the seat cushion
front end and center portion of clutch pedal.
• Slide the seat at seventh notch from first notch.
Specified clutch pedal full stroke A:
130 — 135 mm (5.12 — 5.31 in)
A
(A)
(A) Clutch pedal (Full stroke condition)
(B) Scale
(C) Seat
2) If the clutch pedal stroke is out of specification,
loosen the clutch stopper nut and adjust it.
Tightening torque (Clutch stopper nut):
"
8 N m (0.8 kgf-m, 5.8 ft-lb)
CLUTCH SYSTEM
(B)
CL-00077
(C)
(B)
CL-00078