Subaru Legacy 2004 Service Manual page 2749

CLUTCH SYSTEM
11.Clutch Switch
A: REMOVAL
1) Disconnect the ground cable from battery.
2) Remove the instrument panel lower cover.
3) Disconnect the connector from clutch switch.
4) Remove the clutch switch.
B: INSTALLATION
1) Install the clutch switch and clutch pedal stopper
so that the gap between them is 0 mm (0 in).
Tightening torque:
"
8 N m (0.8 kgf-m, 5.8 ft-lb)
(C)
(A) Clutch switch
(B) Stopper
(C) 0 mm (0 in)
2) Measure the stroke of clutch pedal.
Specified clutch pedal full stroke A:
130 — 135 mm (5.12 — 5.31 in)
A
(A)
(A) Clutch pedal (Full stroke condition)
(B) Scale
(C) Seat
3) If the clutch pedal stroke is out of specification,
adjust the stroke. <Ref. to CL-29, ADJUSTMENT,
Clutch Pedal.>
4) Connect the clutch switch connector.
Clutch Switch
(A)
(B)
CL-00133
(C)
(B)
CL-00078
C: INSPECTION
Check the clutch switch continuity. If continuity is
not as specified, replace the switch.
(1) Disconnect the clutch switch connector.
(2) Measure the resistance between terminal 1
and 2 of switch.
Terminal / Specified resistance
When clutch pedal depressed:
1 — 2/More than 1 M
Terminal / Specified resistance
When clutch pedal not depressed:
1 — 2/Less than 1
D: ADJUSTMENT
Refer to "ADJUSTMENT" for clutch pedal. <Ref. to
CL-29, ADJUSTMENT, Clutch Pedal.>
CL-32
$
$
2 1
CL-00084