Subaru Legacy 2004 Service Manual page 2737

CLUTCH SYSTEM
5. Operating Cylinder
A: REMOVAL
1) Remove the air intake chamber. <Ref. to
IN(H4SO 2.0)-8, REMOVAL, Air Intake Chamber.>
2) Disconnect the clutch hose from operating cylin-
der.
CAUTION:
Cover the hose joint to prevent clutch fluid from
flowing out.
(A)
(B)
(A) Clutch hose
(B) Operating cylinder
3) Remove the operating cylinder from transmis-
sion.
B: INSTALLATION
1) Install in the reverse order of removal.
NOTE:
Before installing the operating cylinder, apply
grease (SUNLIGHT 2: Part No. 003602010) to the
contact point of the release lever and operating cyl-
inder.
Operating Cylinder
Tightening torque:
T1: 18 N
T2: 37 N
2) After bleeding air from the operating cylinder,
ensure that clutch operates properly.
<Ref. to CL-25, Clutch Fluid Air Bleeding.>
C: INSPECTION
1) Check the operating cylinder for damage. If op-
erating cylinder is damaged, replace it.
CL-00252
2) Check the operating cylinder for fluid leakage or
damage on boot. If any leakage or damage is
found, replace the operating cylinder.
CL-00253
CL-20
"
m (1.8 kgf-m, 13.0 ft-lb)
"
m (3.8 kgf-m, 27.5 ft-lb)
T2
T1
T2
CL-00254