14.Transmission Case
A: REMOVAL
1. SINGLE-RANGE
1) Remove the manual transmission assembly
from vehicle. <Ref. to MT-33, REMOVAL, Manual
Transmission Assembly.>
2) Remove the clutch release lever. <Ref. to CL-
26, REMOVAL, Release Bearing and Lever.>
3) Remove the transfer case with extension case
assembly. <Ref. to MT-48, REMOVAL, Transfer
Case and Extension Case Assembly.>
4) Remove the bearing mounting bolts.
5) Remove the main shaft rear plate.
(A) Main shaft rear plate
6) Put vinyl tape around the splines of right and left
axle drive shafts to prevent damage to oil seal.
(A) Vinyl tape
TRANSMISSION CASE
7) Separate the transmission case into right and
left cases by loosening the coupling bolts and nuts.
8) Remove the drive pinion shaft assembly from left
side transmission case.
NOTE:
Use a hammer handle, etc. to remove if too tight.
S3M0099
9) Remove the main shaft assembly.
S3M0100C
B3M1405B
MT-61
MANUAL TRANSMISSION AND DIFFERENTIAL
(A) Main shaft assembly
(B) Drive pinion shaft assembly
B3M1359
B3M0101H