Transmission Case - Subaru IMPREZA 2002 Service Manual

I
TRANSMISSION CASE
MANUAL TRANSMISSION AND DIFFERENTIAL
I
14.Transmission Case
A: REMOVAL
1) Remove the manual transmission assembly
from vehicle. <Ref. to MT-27, REMOVAL, Manual
Transmission Assembly.>
2) Remove the clutch release lever. <Ref. to CL-
15, REMOVAL, Release Bearing and Lever.>
3) Remove the transfer case with extension case
assembly. <Ref. to MT-41, REMOVAL, Transfer
Case and Extension Case Assembly.>
4) Remove the bearing mounting bolts.
5 ) Remove the main shaft rear plate.
I I
S3M0100C
(A) Main shaft rear plate
6) Put the vinyl tape around splines of the right and
left axle drive shafts to prevent damage to oil seal.
7) Separate the transmission case into the right
and left cases by loosening coupling bolts and nuts.
1
03M 1359
8) Remove the drive pinion shaft assembly from left
side transmission case.
NOTE:
Use a hammer handle, etc. to remove if too tight.
(A) Main shaft assembly
(B)
Drive pinion shaft assembly
9) Remove the main shaft assembly.
10) Remove the differential assembly.
CAUTION:
Be careful not to confuse right and left roller
bearing outer races.
Be careful not to damage retainer oil seal.
I
I I
B3M14050
\ \ \
(A) Vinyl tape
MT-54