Table of Contents
Advertisement
7-2. Quick IP address (LAN1) setting
When connecting a TW-50 to a dedicated LAN system, IP address (LAN1) of the TW-50 can be easily set to an
address between 192.168.1.1 and 192.168.1.15 with rotary switch SW1.
When the IP address cannot be set with rotary switch SW1 (e.g., when connecting a TW-50 to an existing LAN,
when the TW-50 is used as an expansion controller of TE-200), set the IP address on the Initial Setting Tool or the
Web Browser for Initial Settings.
Set SW1 before turning on the power.
* The arrow on the rotary switch indicates the current setting of the switch. Point the arrow at the desired number.
* To set the address, turn the rotary switch with a precision slotted screwdriver [2.0 mm (2/16 in) (width)] to a torque of less than
19.6 mN•m.
SW1
IP address (LAN1)
Default
0
192.168.1.1
1
192.168.1.1
2
192.168.1.2
3
192.168.1.3
4
192.168.1.4
5
192.168.1.5
6
192.168.1.6
7
192.168.1.7
8
192.168.1.8
9
192.168.1.9
A
192.168.1.10
B
192.168.1.11
C
192.168.1.12
D
192.168.1.13
E
192.168.1.14
F
192.168.1.15
Note
● If you forget the TW-50 IP address, check the IP address that has been entered on the monitoring PC (Web browser or
TG-2000A).
● If you forget the TW-50 IP address, you can start TW-50 by changing the SW1 setting and temporarily using a certain
IP address (between 192.168.1.1 and 192.168.1.15). The IP address can be changed to an arbitrary IP address by
setting the IP address on the Initial Setting Tool or the Web Browser for Initial Settings, setting the SW1 back to "0", and
rebooting the TW-50. (It is recommended to paste a label with the IP address on the TW-50, so that the IP address is
available at all times.)
WT09308X01
Subnet mask
Default
255.255.255.0
255.255.255.0
24
SW1
Gateway
Default
0.0.0.0
0.0.0.0
Advertisement
Table of Contents
