5. Initial startup settings
5-1. Initial startup setting procedures
5-1-1. TE-200 initial startup for a system without connection to a TE-50/TW-50
controller
(1) After the power is turned on, a language selection screen will
appear.
Select the language to be used for display, and then touch [OK].
Note: It will take approximately one minute for the display to appear
after the power is turned on.
Note: Do not touch the LCD before any settings screen appears.
Note: Once the initial settings have been made, [Monitor/Operation]
screen will appear after the power is turned on.
(2) The [Date and time] screen will appear.
Referring to section 5-2-3, set the current date, current time,
and daylight saving time, and then touch [Save Settings].
(3) Touch the [Unit Info.] and [Unit Info. 2] tabs.
Referring to section 5-2-5, make necessary basic settings, and
then touch [Save Settings].
Note: Make sure to set the [System Exp] setting for the TE-200 to [Do
not expand].
Note: Make sure to set the [AE-200 M-NET] setting to [Use].
WT09304X01
Unit Info.
Unit Info. 2
52