19
Introduction
Overview
This chapter contains an alphabetical list of commands used to configure Power
over Ethernet (PoE). Each command contains a functional description and shows
examples of configuration and output screens for show commands. These
commands are only supported on PoE capable ports. An error message will display
on the console if you enter a PoE command on a port that does not support PoE.
The following documents offer further information for configuring PoE on
AlliedWare Plus switches.
•
•
•
Power over Ethernet (PoE) is a technology allowing devices such as security
cameras to receive power over LAN cabling.
The Powered Device (PD) referred to throughout this chapter is a PoE or PoE+
powered device, such as an IP phone or a Wireless Access Point (WAP).
Command List
•
•
•
•
•
•
•
•
•
C613-50170-01 Rev B
the
PoE Feature Overview and
the
Support for Allied Telesis Enterprise_MIBs_in AlliedWare
information about which PoE MIB objects are supported.
the
SNMP Feature Overview and
SNMP traps.
"clear power-inline counters
"debug
power-inline" on page 728
"power-inline
allow-legacy" on page 730
"power-inline
description" on page 731
"power-inline
enable" on page 732
"power-inline
max" on page 733
"power-inline
priority" on page 735
"power-inline
usage-threshold" on page 737
"service
power-inline" on page 738
Command Reference for x510 Series
AlliedWare Plus™ Operating System - Version 5.4.7-1.x
Power over
Ethernet
Commands
Configuration_Guide.
Configuration_Guide, for information about
interface" on page 727
Plus, for
725