Allied Telesis x510-28GTX Command Reference Manual page 741

P E C
OWER OVER THERNET OMMANDS
-
SHOW POWER INLINE
Table 1: Parameters in the show power-inline command output (cont.)
C613-50170-01 Rev B
Parameter
Operational Status
Power Usage Threshold
(%)
Interface
Admin
Pri
Oper
Power
Command Reference for x510 Series
AlliedWare Plus™ Operating System - Version 5.4.7-1.x
Description
The operational status of the PSU hardware when this
command was issued:
• On if the PSU is installed and switched on.
• Off when the PSU is switched off (an RPS may be
connected to the switch to power PoE instead of the
PSU).
• Fault when there is an issue with the PSU hardware.
The configured SNMP trap / log threshold, as configured
from a power-inline usage-threshold
The PoE port(s) in the format portx.y.z, where x is the device
number, y is the module number within the device, and z is
the PoE port number within the module.
The administrative state of PoE on a PoE port, either
Enabled or Disabled.
The current PoE priorities for PoE ports, as configured using
the power-inline priority
• Low is the lowest priority (this is the default).
• High is the second highest priority.
• Crit (critical) is the highest priority.
If the switch cannot supply all ports, it will supply critical
ports, then high-priority ports, then low-priority ports.
The current PoE port state when this command was issued:
• Powered displays if there is a PD connected and power
is being supplied.
• Denied displays if supplying power would make the
switch go over the power budget.
• Off displays if the port is not supplying power but has
not been denied power by the switch. This is the default
state for ports that are not connected to a PD.
• Disabled displays if the PoE port is administratively
disabled.
• Syncing displays if PoE is still initializing the port when
you issue the command.
• Fault displays if there is a problem with PoE on the port.
• Unknown displays if PoE cannot determine the state of
the port.
The power consumption in milliwatts (mW) for the PoE
port when this command was entered.
command.
command:
741