Gvrp Timer - Allied Telesis x510-28GTX Command Reference Manual

GVRP C
OMMANDS

GVRP TIMER

gvrp timer
Overview Use this command to set GVRP timers in Interface Configuration mode for a given
interface.
Use the no variant of this command to reset the GVRP timers to the defaults
specified in the table below.
Syntax gvrp timer {join <timer-value>|leave <timer-value>|leaveall
<timer-value>}
no gvrp timer {join|leave|leaveall}
Mode Interface Configuration
Defaults The default join time value is 20 centiseconds (200 milliseconds), the default leave
timer value is 60 centiseconds (600 milliseconds), and the default leaveall timer
value is 1000 centiseconds (10,000 milliseconds).
When configuring the leave timer, set it to more than or equal to three times the
Usage
join timer value. The settings for the leave and join timers must be the same
for all GVRP enabled switches. See also the section "Setting the GVRP Timers" in the
GVRP Feature Overview and Configuration
Use the
To set the GVRP join timer to 30 hundredths of a second (300 milliseconds) for
Examples
interface port1.0.1, enter the commands:
awplus#
awplus(config)#
awplus(config-if)#
To set the GVRP leave timer to 90 hundredths of a second (900 milliseconds) for
interface port1.0.1, enter the commands:
awplus#
awplus(config)#
awplus(config-if)#
C613-50170-01 Rev B
Parameter Description
join
Specifies the timer for joining the group (default is 20
centiseconds / hundredths of a second, or 200 milliseconds).
leave
Specifies the timer for leaving a group (default is 60 centiseconds /
hundredths of a second, or 600 milliseconds).
leaveall
Specifies the timer for leaving all groups (default is 1000
centiseconds / hundredths of a second, or 10,000 milliseconds).
<timer-value> <1-65535> The timer value in hundredths of a second
(centiseconds).
show gvrp timer
configure terminal
interface port1.0.1
configure terminal
interface port1.0.1
Command Reference for x510 Series
AlliedWare Plus™ Operating System - Version 5.4.7-1.x
Guide.
command to confirm GVRP timers set with this command.
gvrp timer join 30
gvrp timer leave 90
759