Allied Telesis x510-28GTX Command Reference Manual page 808

IP A P
DDRESSING AND ROTOCOL
SHOW IP SOCKETS
Table 21-1: Parameters in the output from show ip sockets
C613-50170-01 Rev B
C
OMMANDS
Parameter Description
Not showing
This field refers to established sessions between processes internal
<number>
to the device, that are used in its operation and management.
local
These sessions are not displayed as they are not useful to the user.
connections
<number> is some positive integer.
Not showing
This field refers to listening sockets belonging to processes internal
<number>
to the device, that are used in its operation and management. They
local
are not available to receive data from other devices. These sessions
listening
are not displayed as they are not useful to the user. <number> is
ports
some positive integer.
Typ
This column displays the type of the socket. Possible values for this
column are:
tcp : IP Protocol 6
udp : IP Protocol 17
raw : Indicates that socket is for a non port-orientated protocol (i.e.
a protocol other than TCP or UDP) where all packets of a specified IP
protocol type are accepted. For raw socket entries the protocol type
is indicated in subsequent columns.
Local
For TCP and UDP listening sockets this shows the destination IP
Address
address (either IPv4 or IPv6) and destination TCP or UDP port
number for which the socket will receive packets. The address and
port are separated by ':' . If the socket will accept packets addressed
to any of the device's IP addresses, the IP address will be 0.0.0.0 for
IPv4 or :: for IPv6. For active TCP sessions the IP address will display
which of the devices addresses the session was established with.
For raw sockets this displays the IP address and IP protocol for
which the socket will accept IP packets. The address and protocol
are separated by ':' . If the socket will accept packets addressed to
any of the device's IP addresses, the IP address will be 0.0.0.0 for
IPv4 and :: for IPv6. IP Protocol assignments are described
at:www.iana.org/assignments/protocol-numbers
Command Reference for x510 Series
AlliedWare Plus™ Operating System - Version 5.4.7-1.x
808