56
Operating Modes
3.
Go to the Settings menu and click [Communication].
A "Communications settings" dialog box will open.
In this window under Connection select "Serial ports (COM, USB,
Bluetooth, ...)" and under Port "COM1: Communications port".
Then confirm this selection by clicking [OK].
4.
Switch on the supply voltage to your coupler/controller.
5.
When the coupler/controller has booted up click [Identify] on the toolbar.
The set-up of your fieldbus node will be automatically detected and shown
graphically in the node view and also in the navigation bar as a tree
structure.
6.
Move the mouse pointer to the graphical representation of the HART I/O
module or to the I/O module designation in the tree structure and select
"Settings" from the context menu (right mouse button).
Figure 16: WAGO-I/O-CHECK Context Menu „Settings"
7.
In the dialog window that opens for making the settings select the required
operating mode and then click "Write".
Figure 17: WAGO-I/O-CHECK Dialog Window (Example 750-484/000-001)
8.
In the dialog window that opens for making the settings select the required
operating mode and then click "Write".
When the parameters have been set successfully, this will be indicated by a
message.
Manual
Version 1.4.0
WAGO-I/O-SYSTEM 750
750-484 2AI 4-20mA HART Ex i