Table of Contents
Advertisement
8 •
Quick Start
Ethernet Network Start-Up
2.2 Ethernet Network Start-Up
Allocating the IP address is done very conveniently using both the included
serial programming cable and the "WAGO Ethernet Settings" program.
Connect your PC with the configuration and programming interface of the
node.
Install the "WAGO Ethernet Settings" program, which you can find either on
the "Tools & Docs" CD-ROM or on the WAGO Web pages under Service
Downloads
After starting, the program identifies the current settings of the node.
Fig. 2: WAGO Ethernet Settings
If a connection timeout occurs, you can retry the connection by using the
"Identify" button. If the problem persists, check the COM port settings and
cabling.
Software.
WAGO-I/O-SYSTEM 750
ETHERNET StarterKit 2
Advertisement
Table of Contents
