Changing An Ip Address Using The Linux Console (Ipc Configuration Tool); Figure 24: Start Screen Of The Wago Ipc Configuration Tool; Figure 25: Tcp/Ip; 758-874/000-131 Wago-I/O-Ipc-C6 - WAGO -I/O-IPC-C6 Manual

WAGO-I/O-SYSTEM 750

758-874/000-131 WAGO-I/O-IPC-C6

8.3.2 Changing an IP Address Using the Linux Console
(IPC Configuration Tool)
Using the IPC configuration tool accessible on the Linux console, you can assign
the X8 and X9 ETHERNET interfaces a new IP address. For additional
information about the IPC configuration tool, see section "Configuration".
Preparation:
You have connected a monitor to the DVI-I interface and a keyboard to the USB
interface of the I/O-IPC. For more information, see section "Access over DVI-I
and USB Interface".
1. Using the key combination [Alt] + [F3], open the third console of the I/O-
IPC on which the IPC configuration tool is located.

Figure 24: Start screen of the WAGO IPC configuration tool

2. Use the keyboard (arrow keys or number block) to select the TCP/IP entry
and press the [Enter] key.

Figure 25: TCP/IP

Pos: 41.4 /Dokumentation allgemein/Gliederungselemente/---Seitenwechsel--- @ 3\mod_1221108045078_0.doc @ 21810 @ @ 1
Manual
Version 1.0.0
Commissioning 65