Changing An Ip Address Using The Linux Console (Ipc Configuration Tool); Figure 23: Start Screen Of The Wago Ipc Configuration Tool; Figure 24: Tcp/Ip - WAGO -I/O-IPC-C6 Manual

60 Commissioning
8.3.2 Changing an IP Address Using the Linux Console
(IPC Configuration Tool)
Using the IPC configuration tool accessible on the Linux console, you can assign
the X8 and X9 ETHERNET interfaces a new IP address. For additional
information about the IPC configuration tool, see section "Configuration".
Preparation:
You have connected a monitor to the DVI-I interface and a keyboard to the USB
interface of the I/O-IPC. For more information, see section "Access over DVI-I
and USB Interface".
1. Using the key combination [Alt] + [F3], open the third console of the I/O-
IPC on which the IPC configuration tool is located.

Figure 23: Start screen of the WAGO IPC configuration tool

2. Use the keyboard (arrow keys or number block) to select the TCP/IP entry
and press the [Enter] key.

Figure 24: TCP/IP

Pos: 41.4 /Dokumentation allgemein/Gliederungselemente/---Seitenwechsel--- @ 3\mod_1221108045078_0.doc @ 21810 @ @ 1
WAGO-I/O-SYSTEM 750
758-874/000-110 WAGO-I/O-IPC-C6
Manual
Version 2.3.0