Figure 16: Address Selection Switch With Set Ip Address (192.168.1.100); Figure 17: Restarting The Sps Via Hardware Reset - WAGO 750-880 Quickstart Reference

30 Quickstart Description
2. Set the bits in order using the 8 DIP switches. Begin with DIP switch 1 to
set Bit 0 (LSB) and continue up to DIP switch 8 for Bit 7 (MSB).

Figure 16: Address selection switch with set IP address (192.168.1.100)

3. Restart the SPS after adjusting the address selection switch to apply the IP
configuration changes.
To do this, open the cover for the service interface and press the mode
switch down (e.g., using an actuation tool, Item No.: 210-720).

Figure 17: Restarting the SPS via hardware reset

750-880, -881, -882 ETHERNET Programmable Fieldbus
WAGO-I/O-SYSTEM 750
Quickstart Reference
Version 1.0.0