Reset Button; Figure 19: Reset Button - WAGO 750-8207 Manual

WAGO-I/O-SYSTEM 750
750-8207 PFC200 CS 2ETH RS 3G
3.5.2

Reset Button

Figure 19: Reset Button

The Reset button is installed behind drilling to prevent operating errors. It is a
shortstroke button with a low actuating force of 1.1 N ... 2.1 N (110 gf ... 210 gf).
The button can be actuated using a suitable object (e.g., pen).
You can initiate different functions using the Reset button depending on the
position of the mode selector:
- Temporarily set a fixed IP address
- Perform a software reset (restart)
- Restore factory setting (factory reset)
Please refer to the same sections in the back of this manual for information about
the functions.
Draft version 1.2.1 from 2017-09-13, valid from FW Version 02.06.20(09)
Device Description
Manual
45