Operating Elements; Operating Mode Switch; Reset Button; Table 17: Mode Selector Switch - WAGO Compact Controller 100 Manual

34 Properties
4.1.5

Operating Elements

4.1.5.1

Operating Mode Switch

</dg_

Table 17: Mode Selector Switch

Position
RUN
STOP
RESET
</dg_ Other functions can also be initiated using the reset button.
4.1.5.2

Reset Button

The Reset button is installed behind drilling to prevent operating errors. It is a
shortstroke button with a low actuating force of 1.1 N ... 2.1 N (110 gf ... 210 gf).
The button can be actuated using a suitable object (e.g., pen).
You can initiate different functions using the Reset button depending on the
position of the mode selector:
• Temporarily set a fixed IP address ("Fixed IP Address" mode, see section
"Commissioning" > "Setting an IP Address" > "Temporarily Setting a Fixed
IP Address")
• Perform a software reset (restart, see section "Commissioning" > "Initiating
Reset Functions" > "Software Reset")
• Restore factory setting (factory reset, see section "Service" > "Firmware
Changes" > "Factory Reset")
Manual
Version 1.1.0, valid from FW Version 03.08.07(20)
Actuation Function
Normal operation
Latching
e!RUNTIME applications running.
Stop
Latching
All e!RUNTIME applications have stopped.
Reset warm start or
Reset cold start
Spring-return
(depending on length of actuation, see Section
"Starting" > "Initiating Reset Functions")
WAGO I/O System Compact
751-9301 Compact Controller 100