Notes On Data Management; Notes On Reset Commands; Configuration Of The Dali Network Using The Wago Dali Configurator - WAGO 750 Series Manual

60 Commissioning
2. To short-circuit the DALI bus, toggle a button between both DALI bus lines.
•
•
7.5

Notes on Data Management

If online access to the devices on the bus is not possible, you can define virtual
DALI devices as an initial step and match these to the actual installation online at
a later time. Offline configuration of the entire DALI network, including control
gear and control units can be performed in a limited scope using the WAGO DALI
Configurator. Device configurations can also be saved and restored, enabling a
replaced device to be reconstructed using the values valid in the database. This
enables you to copy device settings to a different device or to several ones.
7.6

Notes on RESET Commands

After some commands, some time must be given to DALI subscribers to
complete an operation. For the "RESET" command, that is a time window of 350
ms according to the DIN EN IEC 62386 standard and for the "RESET MEMORY
BANK (DTR0)" command, 10.1 s. No DALI telegrams can be sent to the DALI
bus in that time.
7.7 Configuration of the DALI Network Using the WAGO
DALI Configurator
The following steps are to be performed to configure the DALI Multi-Master
Module and the DALI network linked with the module using the WAGO DALI
Configurator:
1. Define addresses for the DALI devices
2. Configure DALI devices
3. Define DALI groups and scenes
4. Perform diagnosis
Manual
Version 1.4.3
As long as the "System Failure Level" parameter value is greater than
zero for the connected control gear (default value = 100 %), a short
circuit of the DALI bus causes the lighting to switch ON.
If the short circuit lasts approx. 5 seconds (±2 seconds), the "OFF"
command is sent as a broadcast after the short circuit and all control
gear and lighting are switched OFF simultaneously.
WAGO-I/O-SYSTEM 750
753-647 DALI Multi-Master