Reset Button; Figure 13: Reset Button - WAGO I/O System 750 Manual

38 Properties
4.1.6.2

Reset Button

Figure 13: Reset Button

The Reset button is installed behind drilling to prevent operating errors. It is a
shortstroke button with a low actuating force of 1.1 N ... 2.1 N (110 gf ... 210 gf).
The button can be actuated using a suitable object (e.g., pen).
You can initiate different functions using the Reset button depending on the
position of the mode selector:
•
Temporarily set a fixed IP address ("Fixed IP Address" mode, see section
"Commissioning" > "Setting an IP Address" > "Temporarily Setting a Fixed
IP Address")
• Perform a software reset (restart, see section "Commissioning" > "Initiating
Reset Functions" > "Software Reset")
• Restore factory setting (factory reset, see section "Service" > "Firmware
Changes" > "Factory Reset")
Manual
Version 1.7.0, valid from FW Version 04.01.10(23)
WAGO I/O System 750
750-8210/040-000 PFC200; G2; 4ETH; XTR