Table 226: Diagnostics Run Led - WAGO 750-8207 Manual

WAGO-I/O-SYSTEM 750
750-8207 PFC200 CS 2ETH RS 3G
The RUN LED indication depends on the runtime system enabled (CODESYS 2
or e!RUNTIME).
The following indications apply to the CODESYS 2 runtime system:

Table 226: Diagnostics RUN LED

Status
Green
Green flashing
Green/red flashing
Red
Draft version 1.2.1 from 2017-09-13, valid from FW Version 02.06.20(09)
Explanation
PLC program has the
status "Run".
PLC program at a debug
point.
PLC is at a debug point
and the Run/Stop switch
has been set to "Stop".
No PLC-program loaded
or PLC program has the
status "Stop".
Diagnostics 321
Solution
---
Resume the program in
the linked IDE (Integrated
Development
Environment) using
"Single step" or "Start". If
the connection has been
interrupted, set the
Run/Stop switch to "Stop"
and then back to "Run" to
enable the program to
continue.
Set the Run/Stop switch
to "Run" to enable the
program to continue.
Load the PLC program.
Set the Run/Stop switch
to "Run" to start the
current program.
Manual