Diagnostics; Operating And Status Messages; Sys" Led; Run Led - WAGO Compact Controller 100 Manual

112 Diagnostics

10 Diagnostics
10.1

Operating and Status Messages

The following tables contain descriptions of all operating and status messages for
the controller which are indicated by LEDs.
10.1.1

"SYS" LED

10.1.1.1 SYS LED

Table 54: Diagnostics via SYS LED

Status
Green
Orange
Orange flashing "Fix IP Address"
Green/red
flashing
10.1.1.2

RUN LED

Table 55: RUN LED Diagnostics

Status
Green
Green flashing
Red
Green/red
flashing
Red,
goes out briefly
Manual
Version 1.1.0, valid from FW Version 03.08.07(20)
Explanation
Ready to operate -
System start
completed without
errors
Device is in
startup/boot process
and the RST button is
not pressed.
mode,
temporary setting
until the next reboot
Firmware update
mode
Explanation
Applications loaded
and all in the "RUN"
status
No application and
now boot project
loaded
Applications loaded
and all in the "STOP"
status
At least one
application in the
"RUN" status and one
in the "STOP" status
Warm start reset
completed
WAGO I/O System Compact
751-9301 Compact Controller 100
Remedy
---
---
Connect to the device via the standard
address (192.168.1.17) or restart the
device to restore the original value set.
---
Remedy
---
Load an application or boot project.
Set the mode selector switch to "RUN" to
start the application.
Start the stopped application.
---