Configuration" Tab; Plc Runtime Configuration" Page; Table 73: Wbm "Plc Runtime Configuration" Page - "General Plc Runtime - WAGO I/O System 750 Manual

WAGO I/O System 750
750-8210/040-000 PFC200; G2; 4ETH; XTR

"Configuration" Tab

15.2.1.2

15.2.1.2.1 "PLC Runtime Configuration" Page

On the "PLC Runtime Configuration" page, you will find the settings for the boot
project created with the programming software and the settings for the web
visualization created in the runtime system.
"General PLC Runtime Configuration" Group
Table 73: WBM "PLC Runtime Configuration" Page – "General PLC Runtime Configuration" Group
Parameter
PLC runtime version
Home directory on memory
card enabled
All data is deleted when switching the runtime system!
The runtime system's home directory is completely deleted when switching the
runtime system!
Only the first partition can be used as the Home directory!
Only the first partition of a memory card can be accessed at /media/sd and used
as the home directory.
Click [Submit] to apply the change. The runtime system change is effective
immediately.
The home directory change only takes effect after the product restarts. For this
purpose, use the WBM reboot function. Do not switch off the product too early!
Meaning
Select here the PLC runtime system to be enabled.
None No runtime system is enabled.
CODESYS V3 runtime system is
CODESYS V3
enabled.
Define if the home directory for the runtime system
should be moved to the memory card.
The home directory is stored in
Disabled
the internal memory.
The home directory is moved to
Enabled
the memory card.
Version 1.7.0, valid from FW Version 04.01.10(23)
Appendix 175
Manual