Configuration And Parameterization With E!Cockpit; Configuration And Parameterization Via Gsd File; 750-1491 (2Ai Resistor Bridge (Strain Gauge)) Configuration; Profibus Dp Fieldbus Couplers 750-333(/0Xx-000) - WAGO 750 Series Manual

WAGO I/O System 750
750-1491 2AI Resistor Bridge (Strain Gauge)
7.4 Configuration and Parameterization with
e!COCKPIT
The 750-1491 I/O module is supported by the e!COCKPIT commissioning tool
4
starting with version 1.8.0.0 – see manual "2759-0101 e!COCKPIT," Section
"Operating."
7.5

Configuration and Parameterization via GSD File

The I/O module can also be parameterized via PROFIBUS and PROFINET
device description (GSD file).
Behavior after Overwriting with WAGO-I/O-CHECK !
If WAGO-I/O-CHECK is used to overwrite a parameterization made with the
GSD file, the I/O module operates with the WAGO-I/O-CHECK settings until the
PROFIBUS/PROFINET Couplers are restarted.
After restart, the I/O module is re-parameterized via PROFIBUS/PROFINET
using the GSD settings.
7.5.1 750-1491 (2AI Resistor Bridge (Strain Gauge))
Configuration
7.5.1.1

PROFIBUS DP Fieldbus Couplers 750-333(/0xx-000)

When the aforementioned PROFIBUS DP fieldbus devices are used, the process
image size is configured by selecting the corresponding GSD entry.

Table 37: PROFIBUS DP Configuration

Module
750-1491 2 Resistor bridges/SG
750-1491 2 Resist. bridges/SG RA
750-1491 1 Resistor bridge/SG
750-1491 1 Resistor bridge/SG RA
GSD Entry
Sub Module
n/a
Commissioning
PA-Length/
[Byte]
Data Type
I O
INT16
8 n/a
{UINT8, INT16}
12 12
INT16
4 n/a
{UINT8, INT16}
6 6
73
Inst.
4
2
Manual
Version 1.0.0