Displaying Measured Values And Information On Connected Sensors/Actuators; Table 36 Tab For Port Information (Digital Inputs/Outputs X01, X02, Etc.) - WAGO 765-1503/100-000 Product Manual

Commissioning
Tab
Information
Status
Configuration
Process data

10.3.1.3.2 Displaying Measured Values and Information on Connected Sensors/Actuators

The Information tab shows the following information:
• The measured values and states of the port diagnostics
• The information on connected sensors/actuators
Displaying Pin- and Port-Specific Measured Values and States
The Information tab shows the following current measured values for each of pin 1, pin 2
and pin 4 of the selected port:
• Temperature of the pin, measured in °C
• Voltage on the pin, measured in volts
• Current flowing through the pin, measured in amperes
• State of the connection pin
States of the Connection Pin
The possible states of the connection pin are:
• OK
• Short circuit
• Module-internal overload protection has triggered
• Module-internal overtemperature protection has triggered
• Module-internal overvoltage protection has triggered
• Overcurrent
• Undercurrent
• Overtemperature
• Undertemperature
60 Product manual | Version: 2.0.0
16DO FLD EI DC 24V 2.0A
Table 36: Tab for port information (digital inputs/outputs X01, X02, etc.)
Description
Displays the current measured values for temperature, voltage and cur-
rent, as well as the port state, individually for pin 1, pin 2 and pin 4. If an
IO-Link device is connected to the digital input/output, its product data is
also shown. This tab is pre-configured.
Displays status information for the digital input/output.
For displaying and setting port parameters.
Displays the process data.
Figure 12: Information Tab, Port X0i Menu Item (Example View)
765-1503/100-000