Table 106: Wbm "Configuration Of Snmp V1/V2C Parameters" Page - "Actually Configured Trap Receivers" Group - WAGO Compact Controller 100 Manual

WAGO I/O System Compact
751-9301 Compact Controller 100
"Actually configured Trap Receivers" Group
Table 106: WBM "Configuration of SNMP v1/v2c Parameters" Page – "Actually Configured Trap
Receivers" Group
Parameters
Each configured trap receiver has its own area in the display. If no trap receiver
has been configured, "(no trap receivers configured)" is displayed.
IP Address
Community Name
Version
Add new Trap Receiver
IP Address
Community Name
Version
Click the corresponding [Delete] button to delete an existing trap receiver.
Click the [Add] button to add a new trap receiver.
The changes only take effect after the controller restarts. For this purpose, use
the WBM reboot function. Do not shut down the controller too early!
Meaning
The IP address for the trap receiver (management
station) is displayed.
This displays the community name for the trap
receiver configuration. The community name can be
evaluated by the trap receiver.
This displays the SNMP version, via which the traps
are sent: v1 or v2c (traps higher than v3 are
displayed in a separate form).
In this area, you can enter a new trap receiver.
Specify the IP address for the new trap receiver
(management station).
Specify the community name for the new trap
receiver configuration. The community name can be
evaluated by the trap receiver.
The community name can be up to 32 characters
long and must not include spaces.
Specify the SNMP version that will send the traps:
v1 or v2c (traps higher than v3 are configured in a
separate form).
Version 1.1.0, valid from FW Version 03.08.07(20)
Appendix 173
Manual