204 Appendix
15.2.1.2.19 "Configuration of DNS Server" Page
The "Configuration of DNS Server" page displays the DNS service settings.
"DNS Server" Group
Table 106: WBM "Configuration of DNS Server" Page – "DNS Server" Group
Parameter
Service active
Mode
Static Hosts
Add Static Host
IP Address
Hostname
Click the [Submit] button to apply the changes. The changes take effect
immediately.
To accept a new assignment click the [Add] button. The change takes effect
immediately.
Click [Delete] to delete an existing assignment. The change takes effect
immediately.
Manual
Version 1.7.0, valid from FW Version 04.01.10(23)
750-8210/040-000 PFC200; G2; 4ETH; XTR
Explanation
You can enable/disable the DNS server service.
Select the operating mode of the DNS server.
Requests are buffered to optimize
Proxy
throughput.
Relay
All requests are routed directly.
This displays the names for IP addresses. If no
assignment was defined, "No static hosts
configured" is displayed.
You can add static IP addresses and host names
below.
Enter a new static assignment,
e.g., "192.168.1.20:hostname".
You can enter 10 assignments.
Enter a host name.
WAGO I/O System 750