Cassette - Canon iR C6800 Series Service Manual

COPIER > ADJUST > FEED ADJ > RG REFE
decrease the setting of REGIST.
(an increase by 10 will decrease the margin by 1 mm)
double-sided copy, 2nd side:4.0+1.5/-1.0mm
Increase the setting of REGIST.
(an decrease by 10 will decrease the margin by 1 mm)
0 2 4 6 8 10 12 14 1618 20 5
F-12-12
4. Leading Edge Non Image Width Adjustment
Execute the following service mode item:
COPIER > ADJUST > ADJ XY > ADJ X
Decrease the setting of ADJ-X.
(a decrease by 10 will decrease the non-image width by 1 mm)
4.0+1.5/-1.0mm
0 2 4 6 8 10 12 14 1618 20 5
Increase the setting of ADJ-X.
(an increase by 10 will increase the non-image width by 1 mm)
F-12-13
5. Left/Right Non Image Width Adjustment
Execute the following service mode item:
COPIER > ADJUST > ADJ XY > ADJ Y
Decrease the setting of ADJ-X.
(a decrease by 10 will decrease
the non-image width by 1 mm)
F-12-14
Paper leading edge
Image edge
Image edge
Increase the setting of ADJ-Y.
(a decrease by 10 will increase
the non-image width by 1 mm)
2.5 1.5mm/-1.5mm
0
2
4
5
6
8
10

12.2.3 Cassette

Make prints using the cassettes 3 and 4 as the source
of paper, and check to make sure that the left/right
margin is as indicated.
If not as indicated, make the following adjustments:
1) Press the cassette release button, and slide out the
cassette 3 or 4 to the front.
2) Open the upper right cover and the lower right
cover.
3) Insert a screwdriver through the opening in the
front right stay; then, loosen the screw [1], and adjust
the position of the adjusting plate [2].
[2]
[1]
F-12-15
move the adjusting plate toward the rear to increase
the left margin.
move the adjusting plate toward the front to decrease
the left margin.
4) Tighten the screw.
5) Close the upper right cover and the lower right
cover.
6) Put the cassette 3 or 4 back in the machine.
Chapter 12
0003-8720
12-17