[2]
[1]
[3]
F-2-106
5) Fit the 2 claws [1] to mount the heater PCB [2].
- 2 screws (TP; M3X6) [3]
[3]
[1]
[2]
F-2-107
6) Connect the AC connector [1] to the heater PCB, and pass it through the
edge saddle [2].
[1]
[2]
F-2-108
7) Connect the 2 AC connectors [1] to the heater PCB, and pass them through
the edge saddle [2].
[4]
[5]
[1]
[3]
[1]
[1]
[2]
F-2-109
8) Connect the DC connector [1] to the heater PCB, and pass it through the
edge saddle [2].
[1]
F-2-110
9) By reversing the steps used to remove covers, attach the followings:
- lower rear cover
- lattice connector (in the case that the cassette pedestal is mounted)
- rear right cover
- reader power cable
10) In the case that the cassette pedestal is mounted, close the cassette lower
right cover.
11) Close the upper right cover.
12) Turn ON the heater switch.
13) Attach the environment heater switch cover.
2.13 Installing the Cassette Heater for the
Cassette Pedestal
2.13.1 Checking the Parts
iR C3380i / iR C3380 / iR C2880i / iR C2880 / iR C3580 / iR C3580i / iR
C3080 / iR C3080i / iR C2380i
Prepare the following parts because each part of the Cassette Heater Attach-
ment is assigned as service part.
Chapter 2
[2]
0014-2733
2-27