Canon iR C6800 Series Service Manual page 1261

Hide thumbs Also See for iR C6800 Series:

Table of Contents

Use it to change the intervals of post rotation patch detection (video counter count).

Use it to change the intervals of patch ATR in relation to the cumulative video count.

When a specific video count is exceeded, ATR patch detection is executed during last

rotation at the end of the ongoing job, and the limit of the cumulative video count may

be changed. A higher limit will increase the downtime intervals, but will affect the

density. On the other hand, although a lower limit will decease the downtime intervals,

the density will be more stable.

The new setting will not be valid until the power switch has been turned off and then on.

10 to +10 (level: 10% duty/A4)

default: 200% duty (A4, 5% duty x 40 prints)

at time of shipment/RAM initialization: 0

Use it to change the delivery speed.

The new setting will not be valid until the power switch has been turned off and then on.

0: delivery speed with priority on FCOT (627 mm/sec)

1: delivery speed with priority on paper edge damage avoidance (267 mm/sec)

at time of shipment/upon RAM initialization: 0

Use it to enable/disable the message that prompts replacement of the fixing assembly.

Use it to enable/disable the message on the control panel indication the need for the

replacement of the fixing assembly.

Normally, the setting is enabled; however, you can disable the message if there is no

need for replacement (so that the user will not feel unnecessarily concerned and place a

service call). If replacement is necessary, be sure to replace it and enable the setting.

The new setting will not be valid until the power has been turned off and then on.

0: do not indicate

a time of shipment/upon RAM initialization: 1

Chapters

Table of Contents