1/2/3
ITB HP sensor B (PS30)
4/5/6
ITB sensor A (PS1)
[4]Hopper harness (FM2 0950)
1/2
hopper stirring motor
(M23)
3/4/5
hopper inside toner level
sensor (TS2)
6/7
black toner supply motor
(M25)
8/9/10
hopper open/closed
sensor (PS28)
[5]Poteantial sensor harness (FL2 0986) connector: J407L
1 6
potential sensor
E070 00**
The sensor fails to operate.
E070 00**
The sensor fails to operate.
connector: J301L
black developing assembly without toner > image
fault (low density)
The motor stops.
2 min supply error (reset by opening/closing the door)
hopper excess toner supply
The absence of toner is wrongly detected in the
presence of toner.
hopper without toner > black developing assembly
inside without toner
The job stops.
The presence of toner is wrongly detected in the
absence of toner.
hopper without toner > black developing assembly
inside without toner
The job stops.
The hopper is without toner.
message calling for replacement of the bottle, not
permitting recovery.
remains closed.
The black cartridge motor stops.
remains closed
E061 0007
An error potential level is detected.
Chapter 13
13-23