Chapter 7
11) Slightly lift both ends [1] of the process unit, and
fully slide out the process unit [2].
[2]
F-7-119
When you have slid out the process unit, check to see
if any of the following parts is soiled with toner before
fitting it back in; if soiled, dry wipe the part:
entire surface of the deck top panel [1]
front bend of the deck top panel [2]
lower rear sheet (4 locations) of the fixing/feeding
assembly [3].
[1]
[2]
F-7-120
7-82
[1]
[3]
F-7-121
7.11.2.4 Releasing the Hopper
Assembly
1) Open the black toner supply cover [1].
[1]
F-7-122
2) Shift down the lever [1], and detach the black toner
bottle [2].
[2]
F-7-123
Once you have released the hopper assembly, toner
can spill over the toner bottle supply mouth of the
hopper assembly cover. Be sure to wipe off any such
toner.
0003-2511
[1]