Canon iR C6800 Series Service Manual page 432

Chapter 7
7) Supply the remaining half of the starter around the
stirring screw inside the color developing unit.
8) Turn the developing gear 5 to 6 times once again so
that the starter inside the unit is even.
9) Move the starter found on the inner side of the
container wall off the wall.
F-7-545
10) Fit the container lid you removed in step 2) back
on in the direction indicated in the figure.
F-7-546
Thereafter, engage the 4 hooks [1]; then, fix the
container lid [3] in place using the 2 screws [2] you
removed in step 3).
[2]
[3]
[1]
F-7-547
7-166
[1]
Force down the lid against the container so that the
gap [1] indicated in the figure is small enough to
prevent insertion of a transparency.
[1]
F-7-548
When tightening the screw, take full care so that
no shavings caused by turning the screw into the lid of
the developing assembly and the container will move
into the container.
11) Cut off the appropriate tab [1]] to suit the color of
the starter you have supplied. The tab A in the figure
is an extra tab.
[1]
F-7-549
12) Fit the color developing unit by going through the
steps used to detach it but in reverse.
13) Turn on the main power switch.
14) Make the following selections in service mode,
and set '1', and press the OK key:
COPIER>FUNCTION>INSTALL>AINR OFF.
15) Select one of the following service mode items to
suit the color of the starter you have supplied; then,
press the OK key.
if for the Y developing assembly,
COPIER>FUNCTION>INSTALL>INISET Y
if for the M developing assembly,
[A]