<SC TYPE>
Settings
<CC SPSW>
setting
15.6.5.1.5 INT FACE
<AP OPT >
setting
T-15-425
Use it to change the type of machine (self copy/coin vendor machine).
This mode is effective only when the machine soft ID is "Lawson."
Use it to switch between a Lawson model and a self copy model.
0: Lawon model
1: general self copy model
at time of shipment/upon RAM initialization: 0
T-15-426
Use it to select the control card (CC IV/CC V) I/F support level.
0: do not support [at time of shipment/after RAM initialization]
1: support (priority on speed)
2: support (priority on upper limit)
If it is set to '1', the machine may not be ale to make an accurate stop based on
an upper limit, as it puts priority on the maintenance of engine performance.
If it is set to '2', the machine will be able to use proper control based on an
upper limit, but may suffer from a drop in engine performance depending on
which source of paper it uses.
T-15-427
Use it to enable/disable printing from PrintMe (application bundled
with the PS print server unit).
0: permit printing by specific account
1: permit printing by any account [at time of shipment/after RAM
initialization]
2: do not permit printing (permitting only for specific group ID)
Chapter 15
0005-6771
0001-1162
0001-0585
15-209