Chapter 14
14.3.70 E677
Code
Detail
E677
0003
0010
0080
14.3.71 E710
Code
Detail
E710
0001
14.3.72 E711
Code
Detail
Cause/Particulars of detection
E711
There is an IPC communication error.
0002
An error has been detected 4 times or
more within 1.5 sec after the
communication has been interrupted
between the finisher and the printer,
and the machine does not reset.
14-50
Cause/Particulars of detection
There is an external controller error.
An error has been detected by a check
on the configuration when the
external controller is being started up.
A controller for a non Canon machine
is connected.
There is an error in the
communication with the printer after
the external controller has started up
normally.
Cause/Particulars of detection
There is an error in IPC initialization.
The machine fails to become ready within 3 sec
after the IPC chip has started up.
T-14-74
Turn off the main power, and check the cable; then, turn on the
main power.
If the machine fails to start up, re install the system software of the
external controller.
Turn off the main power, and check to see if the controller is an
appropriate type, and check the cable; then turn on the main power.
If the machine fails to reset, re install the system software of the
external controller.
Turn off the main power, and check the cable; then, turn on the
main power.
If the machine fails to start up, re install the system software of the
external controller.
T-14-75
Turn off the main power, and check the
cable; then, turn on the main power.
T-14-76
Turn off the main power, and check the cable; then, turn on the main power.
If the machine fails to reset, check the connector between the finisher and
the copier for poor contact; as necessary, replace the finisher controller/DC
controller.
Remarks
Remarks
Remarks
0005-0315
0005-0316
0005-0317