Canon iR C6800 Series Service Manual page 1250

Chapter 15
<T LW LVL>
Attention
settings range
<NWERR SW>
setting
<FX SPD>
Attention
settings range
15-186
T-15-346
Use it to change the setting at which an alert message is issued for
the level of toner.
The threshold (%) of the level of toner over which the message is
issued to indicate that toner is running short may be changed. A
delay, however, can also result in the absence of toner immediately
after the alert message.
The new setting will not be valid until the power switch has been
turned off and then on.
5 to 100
at time of shipment/upon RAM initialization: 10
T-15-347
Use it to enable/disable network related error messages.
0: disable
enable [at time of shipment/after RAM initialization]
T-15-348
Use it to adjust the speed of the fixing roller.
If the arching of paper between the secondary transfer roller and the
fixing roller is too great, the trailing edge of the paper tends to come
into contact with the intermediate transfer belt, causing traces by
friction. A change to the speed of fixing will also change the speed
of the delivery vertical path roller (fine adjustment) accordingly. A
higher setting will increase the speed.
The setting will not be valid until the power switch has been turned
off and then on.
3 to 3
at time of shipment/upon RAM initialization: 0
0005-6755
0001-0527
0005-6757