Canon iR C6800 Series Service Manual page 990

Chapter 14
When setting Login Information for the LDAP server
to 'Use (security auth.)', the domain name is incorrect.
Cannot complete searching due to timeout. Check the settings.
The search could not be completed within the time
specified under <Search Timeout>.
The number of search results has exceeded limits. Change search conditions and try again.
The number of addresses that meet the search criteria
exceeds the specified maximum number of addresses
to search.
Search condition includes characters that cannot be used with the selected server.
"/" is used in the search criterion.
The combination of characters used in the search
criterion does not constitute an acceptable search
criterion.
There is an unequal number of "(" and ")".
"*" is not placed within "( )".
If <Server LDAP version and character code> is set to
'ver.2 (JIS)', characters other than ASCII Code (0x20
0x7E) are being used.
Cannot start searching because the version setting for the server is incorrect. Check the settings.
Although 'ver. 3' is set as the server LDAP version
number in Register LDAP Server in System Settings
(from the Additional Functions screen), the LDAP
server is running on version 2.
14-6
Cause Remedy
Check the Domain Name setting when Login
Information in Register LDAP Server in System
Settings (from the Additional Functions screen) is set
to 'Use (security auth.)'.
Increase the time setting for Search Timeout in
Register LDAP Server in System Settings (from the
Additional Functions screen).
1. Narrow down the search criteria, and then search
again.
2. Increase the maximum number of addresses to
search.
Remove "/" from the search criterion, and search
again.
Make sure that the characters for the search criterion
are combined properly, and search again.
Omit characters that cannot be used, and search again.
Set Server LDAP version and character code in
Register LDAP Server in System Settings (from the
Additional Functions screen) to 'ver. 2'.