Canon iR C6800 Series Service Manual page 1279

Hide thumbs Also See for iR C6800 Series:

Table of Contents

15.7.1.2 NETWORK

15.7.1.2.1 <PING>

Result (OK/NG)

1) Turn off the main power switch.

2) Connect the network cable to the machine and turn on the main power switch.

3) Inform the user's system administrator that the installation work for the machine is over, and ask him/

her to make necessary network settings.

4) Advise the system administrator that you will be checking the network connection, and obtain the

remote host address (IP address of a PC terminal on the user's network) for PING.

5) Make the following selections in service mode: COPIER>TEST>NETWORK>PING. Then, using

the keypad on the control panel, enter the IP address you obtained in step 4), and press the OK key and

then the Start key.

The machine will indicate 'OK' if the connection to the network is correct. (end of work)

If the machine indicates 'NG', check the connection of the network cable; if it is normal, go to step 6).

If a fault has been found in the connection of the network cable, correct it, and go back to step 5).

6) Make the following selections in service mode: COPIER>TEST>NETWORK>PING. Then, enter

the loopback address* (127.0.0.1), and press the OK key and then the Start key.

Use it to check the connection of the machine to a network (only if TCP/IP).

Use it when checking the connection to the network at time of installation if a

fault occurs in the connection to the network.

IP address input

Chapters

Table of Contents