Chapter 12
12.7.8 When Replacing the
ATR Sensor/Patch Image
Read Sensor
If you have replaced the ATR sensor/patch image read
sensor, be sure to execute the following:
1) Replace the contents of the color developing unit
with starter (3 types).
12-46
12.8 Pickup/Feeding System
12.8.1 Adjusting the Horizontal
0004-4764
Make prints using the cassettes 3 and 4 as the source
of paper, and check to make sure that the left/right
margin is as indicated.
If not as indicated, make the following adjustments:
1) Press the cassette release button, and slide out the
cassette 3 or 4 to the front.
2) Open the upper right cover and the lower right
cover.
3) Insert a screwdriver through the opening in the
front right stay; then, loosen the screw [1], and adjust
the position of the adjusting plate [2].
F-12-97
move the adjusting plate toward the rear to increase
the left margin.
move the adjusting plate toward the front to decrease
the left margin.
4) Tighten the screw.
5) Close the upper right cover and the lower right
cover.
6) Put the cassette 3 or 4 back in the machine.
Registration After Replacing the
Pickup Cassette
[2]
[1]
0003-9954