Canon iR C6800 Series Service Manual page 1339

Service Support Tool Ver. 2.01E (DLM0) Batch Download Control Screen
Batch download list
"iR XXXX Ver2.01"
"Common to C-Boot and N-Boot"
Job
Wait "Turn off the copier, then turn on...
Download iR XXXX_SYSTEM_USen2101
Download iR XXXX_Language_XXja2101
Download iR XXXX_Language_XXen2101
Download iR XXXX_DCON_XXxx2007
Wait "Turn off the copier, then turn on...
Download iR XXXX_RUI_XXja1011
Interface
Network
Device IP:
172.16.1.100
To Unit Selection
Screen
F-16-41
B. Executing Batch Downloading
Memo:
Although it varies from one type of system software to another, a typical session is executed as follows according to
the mode you select:
Be sure to use safe mode, however, if you have formatted the HDD.
<Downloading in Normal mode>
1) Start up the PC and the copier (by turning on the main power while holding down 1+7).
2) Start downloading (SYSTEM, Language, Boot, DCON).
3) Turn off the copier, and start it up again in normal mode.
4) Start downloading (RUI, RCON).
<Downloading in Safe Mode>
1) Start up the PC and the copier (but turning on the main power while holding down 2+8).
2) Start downloading (SYSTEM, Language, RUI).
If you have formatted the HDD, the HDD will be in its initial state at this point.
3) Start downloading (BOOT).
4) Turn off the copier, and start it up again in normal mode.
5) Start downloading (DCON).
6) Turn off the copier, and start it up against in normal mode.
7) Start downloading (RCON).
Path
Not registerd
Not registerd
Not registerd
Not registerd
Not registerd
Confirm firmware versions
Same Ver:Skip/Ver down:Confirm
Confirm Overwrite
Start Batch Download
Chapter 16
16-33